Wash Cycle Information/Sanitized - Bosch SHE55C Use & Care Manual

Hide thumbs Also See for SHE55C:
Table of Contents

Advertisement

Available languages

Available languages

To Remove the Fine Filter:
1. Lift the Fine Filter from the dishwasher floor as shown in Figure
29 and flush it clean by holding it under running water.
To reinstall
the filter system:
1. Return the Fine Filter to its installed position.
2. Place the Large Object Trap/Cylinder Filter Assembly into its installed position in the
dishwasher floor.
3. Turn the ring handle clockwise 1/4 turn until it is locked. The arrow on the ring handle
and the arrow on the Fine Filter should point to each other, as shown by the circle in
Figure 30.
4. Gently pull the ring handle to ensure that the assembly is locked into place.
Figure
27
NOTICE
To avoid possible diswasher
damage,
do not use harsh chemicals,
abrasive cleaners,
scouring
pads (metal
or plastic),
or abrasive cloths/paper
towels to clean your dish-
washer's
exterior
door panel. Your dishwasher's
exterior door panel can be damaged
by doing so.
Clean the Exterior
Door Panel
Colored Doors
Use only a soft cloth that is lightly dampened with soapy water.
Stainless Steel Doors
Use a soft cloth with a non-abrasive cleaner (preferably a liquid spray) made for cleaning
stainless steel. For the best results, apply the stainless steel cleaner to the cloth, then wipe
the surface.
Clean the Door Gasket and Door Seal
Regularly clean the door gasket with a damp cloth to remove food particles and other debris.
Also clean the door seal, located inside the dishwasher at the bottom of the door.
Wash Cycle Information
NOTE: To save energy, this dishwasher has a"Smart Control" that automatically adjust the cycle
based on soil loads and incoming water temperature.
The "Smart Control" makes decisions
that can cause the cycle time and water usage to adjust intermittently.
The cycle times listed
in the Use and Care manual are based on normal soil loads and 120°F incoming water and
will vary based on your actual conditions.
See the Cycles and Options Charts to determine the cycles available for your specific model.
NOTE: On select models, the Half Load feature will reduce the water consumption
by
approximately
30 percent in the Power Scrub Plus, and Regular cycles.
To open
- turn
counterclockwise.
Figure
28
Large Object
Trap/Cylinder
Filter
Figure
29
Figure
30
To close - turn
clockwise.
16

Advertisement

Chapters

Table of Contents
loading

Table of Contents