Table of Contents
Advertisement
3. Use a flat-tip screwdriver to
remove the holding clip from the
inner fender.
4. Pull the inner fender cover away
from the fender.
CLIP
5. Remove the socket from the turn
signal assembly by turning it one-
quarter turn counterclockwise.
6. Pull the burned out bulb straight
out of its socket.
Push the new bulb straight into
the socket until it bottoms.
7. Insert the socket back into the
turn signal assembly. Turn it
clockwise to lock it in place.
8. Turn on the lights to make sure
the new bulb is working.
9. Put the inner fender cover in place.
Install the holding clip.
Lock the clip in place by pushing
on the center.
Install the wheel arch protector
and tighten the screws securely.
Lights
CONTINUED
205
Advertisement
Chapters
Table of Contents
