GE AGV18 Owner's Manual & Installation Instructions page 5

ge.com
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
Power Outage Recovery Feature
In tile case of a power outage or interruption, tile
unit will automatically re-start in tile settings last
used after the power is restored. If the
TtmER
teatm'e was set, it will resume its countdown.
_m may need to set a new time if' desired.
COOt Mode
Use tile COOLmode with HIGH (F3), MEB (F2)(>r
LOW(FI) fm_ fin" cooling. Use tile INCREASEA/
BECREASEVpads
to set tile desired temperature
between 60°F and 86°F in 1°F increments.
An electronic thennostnt is used to maintain tile
I'O()I// teI/lpeI'_fftll'e. Tile COl//piessoY win
cycle
on
and off to kee I) tile room at tile set le\ el of COlll]_()/'t.
Set tile themlosmt at a lower number and tile indoor
air will become coole_: Set tile themlosmt at a higller
number and tile indoor air will become wanne_:
NOTE" If theair conditioner i soff andis thenturned on
whileset to a COOL sett/bgor if turnedfroma fansett/bg
toa COOtsett/bg,it will takeapprox/}_Tately 3 mbutes
forthecompressor tostartandcool/bg to beg/b.
CoolingDescriptions
For Normal Cooling--Select tile COOLmode and
HIGH (F3) or MEO (F2)fim with a middle set
temper;fftlre.
For max#nnm Cooling--Select tile COOLmode
and HIGH (/3)tim with a lower set temperature.
For Quieter& Nighttime Cooling--Select the
COOL m ode and LOW (1:1)tim with a middle set
tel/lperattll'e,
NOTE: if youswitchfroma COOtsett/bgto OFFor to
a fansett/bg,wait at least3 m/butes beforeswitch/bg
backtoa COOL sett/bg.
FAN Mode
Use tile FAN at HIGH (/3), IVIED (F2)or LOW (FI) to
provide air circulation and filtering without cooling.
Since tim only settings do not provide cooling,
a temperature setting will not be displayed.
Vent Control
Tile ;'ent control is h)cated on tile inside oI tile air
hmvers on tile lower right side.
When
set at CLOSE,only tile air inside tile room will
be circulated and conditioned. X&q/en set at OPEN,
some inside air is exhausted outside.
To open tile vent, pull tile lever toward you.
T() close it, push it in.
Air Direction--Up and Down
Fingertip pressure on tile bank of horizontal louvers
a(!jtlsts tile air direction tl I) or down.
5