Warning Messages - Sony SRR1000 Operation Manual

Warning Messages

When one of the problems described below is detected by
the unit, a warning mark and message appear on the status
bar. Operation can continue even when the warning mark
appears. When multiple errors occur simultaneously, the
number of errors is indicated to the right of the warning
mark.
If you press the SFT button and DIAG button while the
warning mark appears, the maintenance information
display appears, showing the details of the warning
message. A short warning message is displayed on the
status bar for long warning messages. The maintenance
information display shows the whole warning message.
Only one warning message will be displayed even when
multiple problems occur, but you can use the cursor
buttons to check the errors.
After a warning message is displayed, eliminate the cause
of the warning based on the message.
For details on eliminating the causes of warning
messages, see the Maintenance Manual.
To display warning messages as pop-ups
Press the [F2] – [F7] – [F3] (WARN) buttons in the SETUP
menu to change the setting to On.
1)
Code Indication
010100 NO EXTERNAL REFERENCE
(NO EXT REF)
020100 LOST LOCK
0601pp PORT x SDI A-B PHASE NG
(P-x A-B PHASE)
0801pp PORT x NO SDI-A INPUT
(P-x NO SDI-A)
0802pp PORT x NO SDI-B INPUT
(P-x NO SDI-B)
110100 AUDIO PLL UNLOCKED
(AUD PLL UNLCK)
1901pp PORT x NO A1/A2 INPUT
(P-x NO A1/A2)
1A01pp PORT x NO A3/A4 INPUT
(P-x NO A3/A4)
1B01pp PORT x NO A5/A6 INPUT
(P-x NO A5/A6)
1C01pp PORT x NO A7/A8 INPUT
(P-x NO A7/A8)
1D01pp PORT x NO A9/A10 INPUT
(P-x NO A9/10)
1E01pp PORT x NO A11/A12 INPUT
(P-x NO A11/12)
60
Troubleshooting
2)
Warning message
Meaning
No reference signal is input to the selected REF. INPUT
connector. The unit is using the internal reference signal.
Synchronization was lost during playback, recording, or
editing.
The signals input to the HD SDI INPUT A/B connector at
the indicated port are out of phase with each other.
Signal input to the HD SDI INPUT A connector at the
indicated port cannot be detected.
Signal input to the HD SDI INPUT B connector at the
indicated port cannot be detected. This message appears
only for a signal format that uses the HD SDI INPUT B
connector.
PLL of the audio clock generator is not locked to the video
reference signal.
No carrier detected on digital audio input on channel 1/
channel 2 for the indicated port.
No carrier detected on digital audio input on channel 3/
channel 4 for the indicated port.
No carrier detected on digital audio input on channel 5/
channel 6 for the indicated port.
No carrier detected on digital audio input on channel 7/
channel 8 for the indicated port.
No carrier detected on digital audio input on channel 9/
channel 10 for the indicated port.
No carrier detected on digital audio input on channel 11/
channel 12 for the indicated port.