Sony VPL-EW246 Operating Instructions Manual page 28
User manual (data projector)
Hide thumbs
Also See for VPL-EW246:
- Service parts (1 page) ,
- Quick reference manual (151 pages) ,
- Operating instructions manual (81 pages)
Table of Contents
Advertisement
Items
Direct Power On
Notes
*1:
This may not be optimum depending on the input signal. In this case set manually according
to the connected equipment.
*2:
When "Standby Mode" is set to "Low," the network and network control function cannot be
operated while the projector is in standby mode.
*3:
This varies depending on the "Lamp Mode" setting.
*4:
As the lamp is dimmed gradually, you may not notice any change in brightness. You might only
notice that the lamp has dimmed when its brightness is restored after there is a change in input
signal.
*5:
This mode does not work for about three minutes after the lamp lights. A change in signal may
not be detected depending on the input image. The lamp may become brighter at intervals
during lamp dimming. However, this is not a malfunction. If With No Input is set, it takes
priority.
*6:
Select "Off" to avoid entering standby mode when there is no input signal.
*7:
Does not function when "Type A USB", "Type B USB" or "Network" is selected as the input.
In this case, it becomes equivalent to "Standard."
*8:
Reflecting changes in WLAN settings may take a few moments.
*9:
To set the IP address manually, select "Manual", press "Apply", then enter the IP address.
*10: When you send images or files from a tablet device and display them (page 37), USB wireless
LAN module IFU-WLM3 (optional) can be used as a wireless access point.
*11: The factory default settings for "Manual" are as follows.
SSID: VPL + MAC address for LAN
Security Method: WEP(64bit)
Password: sony1
To change the settings for "Manual", use a web browser.
If "Manual" is set, when you use Presentation Function via Network (page 35), select "Manual
Connect" to connect to the network.
28
The Connection/Power Menu
Item descriptions
On/Off: When set to "On," you can turn the power on without going to
Standby mode when the AC power cord is connected to a wall outlet.
With the projector turned off, you can also unplug the AC power cord
without going to Standby mode, regardless of the Direct Power On
setting.
Hide quick links:
Advertisement
Table of Contents
