Back to Contents Page
Power Connector
Dell™ Latitude™ Z600 Service Manual
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Power Connector
NOTE:
You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in
Before Working Inside Your
2. Remove the
battery
from the computer.
3. Remove the
hinge covers
from the computer.
4. Remove the
access panel
from the computer.
5. Remove the screw that secures the power connector to the computer.
6. Remove the power connector cover from the computer hinge.
7. Disconnect the power connector cable from the system board.
8. Remove the power connector from the computer.
Replacing the Display Assembly
To replace the display assembly, perform the above steps in reverse order.
Back to Contents Page
Computer.