Prerequisites; Enable Rtls Service On The Airwave Server - Dell PowerConnect W-Airwave Manual

Figure 27

Prerequisites

You will need the following information to monitor and manage your Dell PowerConnect W-Series
infrastructure.
Ensure AirWave server is already monitoring Dell PowerConnect W-Series infrastructure

Ensure WMS Offload process is complete

Ensure firewall configuration for port 5050 (default port) supports bidirectional UDP communication

between the AirWave server's IP address and each access point's IP address

Enable RTLS service on the AirWave server

To enable RTLS service on the AirWave server, follow these steps:
1. Navigate to AMP Setup > General and locate the AMP Additional Services section
2. Select Yes for the Enable RTLS Collector option.
3. A new section will automatically appear with the following settings:
RTLS Port - the match controller default is 5050

RTLS Username - match the SNMPv3 MMS username configured on controller

RTLS Password - match the SNMPv3 MMS password configured on controller

Figure 28
40 | Increasing Location Accuracy
Typical Tag Deployment
RTLS Fields in AMP Setup > General
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide