Wms Offload With Airwave; Define Airwave As A Trap Host Using Arubaos Cli - Dell PowerConnect W-Airwave Manual

audit these setting (display mismatches) and you will need to apply to the controller by hand. See
"ArubaOS and AirWave CLI Commands"
These are the commands pushed by AirWave while enabling WMS Offload (do not enter these commands):
configure terminal
no mobility-manager <Active WMS IP Address>
wms
general collect-stats enable
stats-update-interval 120
show wms general
write mem

WMS Offload with AirWave

To offload WMS on the Dell PowerConnect W-Series controllers using AirWave:
1. In AMP Setup > General, locate the Device Configuration section and enable or disable Allow WMS
Offload Configuration in Monitor-Only Mode.
2. Select Save and Apply. This will push a set of commands via SSH to all Dell PowerConnect W-Series master
controllers. If the controller does not have an SNMPv3 user that matches the AirWave database it will
automatically create a new SNMPv3 user. AirWave must have read/write access to the controllers in order to
push these commands
3. Navigate to Groups > Basic and locate the Dell PowerConnect W section.
4. Set the Offload WMS Database field to Yes, as shown in
NOTE: This process will not reboot your controllers. See
ArubaOS CLI to enable stats or WMS Offload.
CAUTION: The SNMPv3 user's Auth Password and Privacy Password must be the same.
Do not enter these commands; these are pushed by AirWave while enabling WMS Offload.
configure terminal
mobility-manager <AMP IP> user <AMP SNMPv3 User Name> <AMP Auth/Priv PW>
stats-update-interval 120
write mem
NOTE: AirWave will configure SNMPv2 traps with the mobile manager command.

Define AirWave as a Trap Host using ArubaOS CLI

To ensure the AirWave server is defined a trap host, access the command line interface of each controller (master
and local), enter "enable" mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
18 | AirWave and Dell PowerConnect W-Series Integration Strategies
for detailed instructions.
Figure 10.
Appendix A, "ArubaOS and AirWave CLI
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide
Appendix A,
Commands"on how to utilize the