Table of Contents
Advertisement
L i f e B o o k S S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed.
Main
Type:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Type:
Auto
None
CD-ROM
SuperDisk
Hard Disk
Cylinders:
A number
between 0
and 65,535
Heads:
A number
between 1
and 16
Sectors:
A number
between 0
and 63
6
PhoenixBIOS Setup Utility
Primary Master [FUJITSU MHM2200AT-(PM)]
[Auto]
20004MB
[16 Sectors]
[Enabled]
[Fast PIO 4]
[Ultra DMA 2]
Select Item
Select Menu
Figure 2. Primary Master Submenu
Default
[Auto]
–—
–—
–—
Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
-/Space
Change Values
Enter
Select
Sub-Menu
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM if a
CD-ROM drive is installed at this connection. If User is selected,
you must specify the number of Cylinders, Heads, and Sectors for
the drive. Select ATAPI Removable if a removable disk drive is
installed at this connection.
This item appears only when Hard Disk is selected. When selected,
you can change the value. This field is changed by incrementing
(pressing the [Spacebar]) or by typing in the number.
This item appears only when the type is identified as Hard Disk.
When selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when the type is identified as Hard Disk.
When selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
F9
Setup Defaults
F10
Save and Exit
Advertisement
Table of Contents
