Mb Intelligent Tweaker(M.i.t.) - Gigabyte GA-M750SLI-DS4 User Manual

2-3

MB Intelligent Tweaker(M.I.T.)

CPU Frequency
HT Link Frequency
PCIE Clock
CPU Clock Ratio
Memory Controller Freq.
DRAM Configruation
******** System Voltage Optimized
System Voltage Control
x DDR2 Voltage Control
x VCC12_HT Voltage Control
x NB_VCC Voltage Control
x 1V1_DUAL Voltage Control
x CPU NB VID Control
x CPU Voltage Control
Normal CPU Vcore
: Move Enter: Select
F5: Previous Values
• Whether the system will work stably with the overclock/overvoltage settings you made is
dependent on your overall system configurations. Incorrectly doing overclock/overvoltage
may result in damage to CPU, chipset, or memory and reduce the useful life of these
components. This page is for advanced users only and we recommend you not to alter the
default settings to prevent system instability or other unexpected results. (Inadequately
altering the settings may result in system's failure to boot. If this occurs, clear the CMOS
values and reset the board to default values.)
• When the System Voltage Optimized item blinks in red, it is recommended that you set
the System Voltage Control item to Auto to optimize the system voltage settings.
CPU Frequency
Allows you to manually set the CPU host frequency. The adjustable range is from 200 MHz to 600 MHz.
Important It is highly recommended that the CPU frequency be set in accordance with the CPU
specifications.
HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto
200 MHz~1.8 GHz Sets HT Link Frequency to 200 MHz~1.8 GHz.
PCIE Clock
Allows you to manually set the PCIe clock frequency. The adjustable range is from 100 MHz to
200 MHz. (Default: 100)
CPU Clock Ratio
Allows you to alter the clock ratio for the installed CPU. The adjustable range is dependent on the
CPU being used. (Default: Auto)
(Note) This item appears only if you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
MB Intelligent Tweaker(M.I.T.)
(Note)
********
(Note)
+/-/PU/PD: Value
F6: Fail-Safe Defaults
BIOS will automatically adjust the HT Link Frequency. (Default)
[200]
[Auto]
[100]
[Auto]
[Auto] 1800Mhz
[Press Enter]
[Auto]
Normal
Normal
Normal
Normal
Normal
Normal
1.2500V
F10: Save
- 39 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
BIOS Setup