Gigabyte GA-M52LT-D3 User Manual page 66

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Un-
der Integrated Peripherals, make sure NV SATA Controller is enabled. To enable RAID, go to the Serial-
ATA RAID Config (Figure 1).
On-Chip IDE Channel
NV SATA Controller
IDE Prefetch Mode
 Serial-ATA RAID Config
Onboard Audio Function
On-Chip MAC Lan
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
USB Controllers
USB Legacy Function
USB Storage Function
higf : Move Enter: Select
F5: Previous Values
Set NV SATA RAID function to Enabled to enable RAID control for each SATA connector. Then set NV
SATA 1 Primary RAID and NV SATA 1 Secondary RAID to Enabled. (Figure 2).
NV SATA RAID function
NV SATA 1 Primary RAID
NV SATA 1 Secondary RAID
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Appendix
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Serial-ATA RAID Config
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[Enabled]
[Enabled]
[Press Enter]
[Auto]
[Auto]
[Disabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
[Enabled]
[Enabled]
[Enabled]
F10: Save
Figure 1
[Enabled]
[Enabled]
[Enabled]
F10: Save
Figure 2
- 66 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults