Memory Problems; Modem Problems; Parallel, Serial And Usb Device Problems; Pc Card Problems - Fujitsu LifeBook E8110 User Manual

E8110.book Page 54 Tuesday, February 28, 2006 2:59 PM
L i f e B o o k E 8 0 0 0 N o t e b o o k
Problem
You have installed an Your external device is not
external keyboard or properly installed.
mouse, and it does not
Your operating system soft-
seem to work.
ware is not set up with correct
software driver for that device.
You have connected an Your operating system soft-
external keyboard or a ware is not setup with correct
mouse and it seems to be software driver for that device.
locking up the system.
Your system has crashed.

Memory Problems

Your Power On screen does Your memory upgrade module
not show the correct is not properly installed.
amount of installed
memory.
You have a memory failure.

Modem Problems

Messages about modem Messages about modem
operation. operation are generated by
whichever modem application
is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel The device is not properly
port device, a serial port installed.
device or a USB device.
The device may have been
Your LifeBook notebook
installed while an application
does not recognize the
was running, so your notebook
device, or the device does
is not aware of its installation.
not seem to work properly.
Your device may not have the
correct software driver active.
You may have the wrong I/O
address selected for your
device.
Your device and another device
are assigned the same I/O
address.
Parallel port is set to output
only.
PC Card/ExpressCard Problems
A card inserted in the PC The card is not properly
Card or ExpressCard slot installed.
does not work or is locking
up the system.
54
Possible Cause
Re-install your device. (See Device Ports on page 46
for more information)
Check your device and operating system docu-
mentation and activate the proper driver.
Check your device and operating system
documentation and activate the proper driver.
Try to restart your notebook. I
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 44
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 60 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 46 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 29 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.
Remove and re-install the card. (See PC Cards/
ExpressCards™ on page 42 for more information)
Possible Solutions