Table of Contents
Advertisement
Installation Requirements
3.7 Mounting
3.7.1 Checks before mounting the drive
Before mounting the optical disk drive in the system cabinet, check whether the
jumper settings are set correctly.
3.7.2 Mounting procedure
How the drive is mounted depends on the system cabinet structure. Determine the
mounting procedure in consideration of the requirements of each system. This
section contains the general mounting procedure and check items.
See Section 3.2 for details on mounting drive.
1) Tighten four mounting screws to secure the drive in the system cabinet.
−
−
−
−
2) After securing the drive, make sure that the drive does not touch the chassis of
the system cabinet. There must be at least 1.5 mm clearance between the
drive and chassis. (See Figure 3.6)
3-24
The drive has ten mounting holes (both sides: 3 × 2, bottom: 4). Secure
the drive using the four mounting holes on both sides or the bottom.
Use mounting screws whose lengths are 3 mm or less from the external
wall of the mounting frame of the drive when they are tightened. (See
Figure 3.6)
When mounting with screws, the screw tightening torque should be 0.4 to
0.45Nm (4 to 4.6kgfcm).
Be careful not to damage the parts on the PCA when mounting the drive.
C156-E224-01EN
Advertisement
Table of Contents
