Installing Sail Switch - Honeywell HE260A1010 - Whole House Humidifier Installation Instructions Manual

Installation guide
Table of Contents

Advertisement

BRASS COMPRESSION NUT
Fig. 9. Installing feed tubing.
4. Connect a 1/2 in. (13 mm) drain tube to the humid-
ifier drain fitting and run to the floor drain (see Fig.
10).
a. Slide the drain clamp over the tubing.
b. Push the tubing over the drain nipple on the
humidifier.
c. Hand-tighten the clamp around the tubing to
secure the humidifier drain.
d. Fasten the drain tubing (can use duct tape)
along the route to prevent movement and
ensure downward slope for correct drainage.
NOTE: Cut tubing to correct length so the tubing termi-
nates at the drain.
Fig. 10. Installing drain tubing.

Installing Sail Switch

Adapting Switch to Air Flow Direction
The S688A Sail Switch is provided with two
counterbalancing springs in place as shown in Fig 11.
These springs offset the effect of gravity for air flow
direction.
PLASTIC
COMPRESSION RING
BRASS INSERT
M20176
M20177
HE220, HE260 HUMIDIFIER INSTALLATION KIT
IMPORTANT:
Do not use the sail switch with both springs
attached. Be sure to select air flow direction and
remove spring(s) not required for installation.
Fig. 11. Adapting sail switch to air flow direction or
mounting position.
• Vertical downward air flow: Leave the spring in
place that is attached to the bracket marked Down.
Remove the spring that is attached to the bracket
marked Up.
• Vertical upward air flow: Leave the spring in place
that is attached to the bracket marked Up. Remove
the spring that is attached to the bracket marked
Down.
• Horizontal air flow: Remove both springs.
1. Mount the template (provided with the sail switch)
at the desired location.
NOTE: Be sure the arrow (indicating air flow) points in
the correct direction.
a. For horizontal mounting, level the long dimen-
sion shown on the template.
b. For vertical mounting, plumb the long dimen-
sion.
2. Cut the hole indicated on the template in the duct-
work.
3. Center punch the screw holes indicated and drill
out with a 1/8 in. (13 mm) drill.
4. Attach the sail to the switch as shown in Fig 12.
5
69-1570

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

He220He260

Table of Contents