Config Rmon Trap; Show Rmon - D-Link DGS-3620-52P Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
IP Interface
IPv4 Address
IPv6 Address
DGS-3620-28SC:admin#

66-22 config rmon trap

Description
This command is used to configure the trap state for RMON events.
Format
config rmon trap {rising_alarm [enable | disable] | falling_alarm [enable | disable]}
Parameters
rising_alarm - (Optional) Specify the trap state for rising alarm. The default state is enabled.
enable - Enable the trap state for rising alarm.
disable - Disable the trap state for rising alarm.
falling_alarm - (Optional) Specify the trap state for falling alarm. The default state is enabled.
enable - Enable the trap state for falling alarm.
disable - Disable the trap state for falling alarm.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable the trap state for RMON:
DGS-3620-28SC:admin#config rmon trap rising_alarm disable
Command: config rmon trap rising_alarm disable
Success.
DGS-3620-28SC:admin#

66-23 show rmon

Description
This command is used to display RMON related settings.
Format
show rmon
Parameters
None.
: ipif4
: None
: 3000::52
725