D-Link DGS-3120-24PC Manual page 747

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
long.
attack_log_toTFTP – Specify that the attack log will be uploaded to the TFTP server.
<ipaddr> - The IP address of the TFTP server.
<ipv6addr> - The IPv6 address of the TFTP server. (EI Mode Only)
dest_file - Used to identify the parameter "path_filename".
<path_filename 64> - Specify the path name on the TFTP server to hold the attack log.
This name can be up to 64 characters long.
unit - (Optional) The attack log messages on the specified unit will be uploaded to the
TFTP server. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID.
firmware_toTFTP – Specify that the firmware file will be uploaded to the TFTP server.
<ipaddr> - The IP address of the TFTP server.
<ipv6addr> - The IPv6 address of the TFTP server. (EI Mode Only)
dest_file - Used to identify the parameter "path_filename".
<path_filename 64> - The pathname specifies the pathname on the TFTP server. It
can be a relative pathname or an absolute pathname. This name can be up to 64
characters long.
unit - (Optional) Specify which unit on the stacking system. If it is not specified, it refers to
the master unit.
<unit_id> - Enter the unit ID value.
src_file - (Optional) Used to identify the parameter "path_filename".
<pathname> - The pathname specifies an absolute pathname on the device file
system. If pathname is not specified, it refers to the boot_up image. This name can
be up to 64 characters long.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To upload firmware from a file system device to a TFTP server:
DGS-3120-24TC:admin# upload firmware_toTFTP 10.1.1.1 dest_file D:/firmware.had
src_file 100b70.had
Command: upload firmware_toTFTP 10.1.1.1 dest_file D:/firmware.had src_file
100b70.had
Connecting to server................... Done.
Upload firmware........................ Done.
DGS-3120-24TC:admin#
In case that the designated file does not exist:
DGS-3120-24TC:admin# upload firmware_toTFTP 10.1.1.1 dest_file D:/firmware.had
src_file 100b70.had
Command: upload firmware_toTFTP 10.1.1.1 dest_file D:/firmware.had src_file
100b70.had
No such file.
Failure!
DGS-3120-24TC:admin#
743