Safety Instructions - MSI AE2200 User Manual

Preface

Safety Instructions

1. Always read the safety instructions carefully.
2. Keep this user's manual for future reference.
3. Keep this equipment away from humidity.
4. Lay this equipment on a flat and steady surface before setting it up.
5. The ventilator on the enclosure is used for air convection and to prevent the
equipment from overheating. Do not cover the ventilator.
6. Check the AC input: 100-240V~, 50-60Hz, 4A.
7. Make sure that the power voltage is within its safety range and has been ad-
justed properly to the value of 100~240V before connecting the equipment
to the power inlet.
8. Place the power cord in a way that people are unlikely to step on it. Do not
place anything on the power cord.
9. Always unplug the power cord before inserting any add-on card or module.
10. All cautions and warnings on the equipment should be noted.
11. Never pour any liquid into the opening that could damage or cause electrical
shock.
12. If any of the following situations arises, get the equipment checked by ser-
vice personnel:
■ The power cord or plug is damaged.
■ Liquid has penetrated into the equipment.
■ The equipment has been exposed to moisture.
■ The equipment does not work well or you can not get it work according to
user's manual.
■ The equipment has dropped and damaged.
■ The equipment has obvious sign of breakage.
13. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT UNCONDI-
TIONED, STORAGE TEMPERATURE ABOVE 40
AGE THE EQUIPMENT.
WARNING:
1. For every changes in power cord's usage, please use an approved power
cord with condition greater or equal to H05VV-F, 3G, 0.75mm
2. Internal part is hazardous moving parts, please keep fingers and other body
parts away.
3. For pluggable equipment, the socket-outlet shall be installed near the equip
ment and shall be easily accessible.
4. Do not disable the protective earth pin from the plug, the equipment must be
connected to an earthed mains socket-outlet.
5. Adjustment of the volume control as well as the equalizer to other settings
than the center position may increase the ear-/ headphones output voltage
and therefore the sound pressure level.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer.
廢電池請回收
For better environmental protection, waste batteries should be collected
separately for recycling or special disposal.
1. The optical storage devices are classified as a Class 1 Laser prod-
ucts. Use of controls or adjustments or performance of procedures
other than those specified is prohibited.
2. Do not touch the lens inside the drive.
C (102
o
iv
F), IT MAY DAM-
o
.
2