WARNING
Disconnect power source before working on
unit.
This is a pin type lamp base and the lamp's
glass is fragile. To remove, pull out carefully.
4W night lamp has threade d base. Remove by
turning counterclockwise.
Make sure the temperature of lens and
lighting unit has cooled down before
maintenance(cleaning) or replacement
of lamp.
CAUTION
Remove dust and dirt from light cover
and lens, before replace the lamps.
1. Remove grille by pulling down the mounting
spring in the right side of "Panasonic" logo.
(Fig.16)
2.Remove plug connector then pull down
the other mounting spring.
(Squeeze mounting spring and pull down
carefully.) (Fig.17)
3. Remove the screw as shown in step 1 of Fig.18.
Remove the light cover as shown in step 2 of
Fig.18.
4
5. Replace the
4W night lamp (Max 4W incandescent
lamp).
(Fig.19 )
Install the
fluorescent lamps (Maxlite MLS13GU35
13W) as shown in step 2 and step 3 of Fig. 6
(page 7).
6. Reinstall the light cover.(Fig.20)
10
Fig.19.
Fig.16
Mounting
spring
Lighting unit
Fig.17
Fig.18
Lens
Fig.19
Fig.20