Alpine INE-W940 Owner's Manual page 89

Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
INE-W940/INE-NAV-40/
INE-W940S
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when INE-W940/INE-NAV-40/INE-W940S is used individually.
• If the switched power (ignition) lead of the INE-W940/INE-NAV-40/INE-W940S is connected directly to the positive (+) post of the vehicle's
battery, the INE-W940/INE-NAV-40/INE-W940S draws some current (several hundred milliamperes) even when its switch is placed in the OFF
position, and the battery may be discharged.
IMPORTANT
Please record the serial number of your unit in the space provided
below and keep it as a permanent record. The serial number plate is
located on the bottom of the unit.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
ACC
(Red)
BATTERY
(Yellow)
SERIAL NUMBER:
INSTALLATION DATE:
INSTALLATION TECHNICIAN:
PLACE OF PURCHASE:
FUSE (5A)
SPST SW (Optional)
(Optional)
FUSE (20A)
(Optional)
Battery
89
-EN