Speaker Connection; Connecting The Speakers Cables - Marantz PM6005 Owner's Manual

Contents

Speaker connection

NOTE
• Disconnect this unit's power plug from the power outlet before connecting the
speakers.
• Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and – sides touch each other (vpage 40 "Protection circuit").
• Never touch the speaker terminals while the power cord is connected.
• Use speakers with impedances within the ranges shown below to suit how they
are used.
Speakers used
SPEAKERS A
(Standard connection)
SPEAKERS B
SPEAKERS A and SPEAKERS B
SPEAKERS A and SPEAKERS B
(for bi-wiring connections)
Front panel Rear panel
Connections Playback
Impedance
4 – 16 Ω/ohms
4 – 16 Ω/ohms
8 – 16 Ω/ohms
4 – 16 Ω/ohms
Remote
Settings

Connecting the speakers cables

Carefully check the left (L) and right (R) channels and + (red) and – (black)
polarities on the speakers being connected to the unit, and be sure to
connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of
sheathing from the tip of the speaker
cable, then either twist the core wire
tightly or apply solder to it.
2
Turn the speaker terminal
counterclockwise to loosen it.
3
Insert the speaker cable's core wire to all
the way into the speaker terminal.
4
Turn the speaker terminal clockwise to
tighten it.
15
Index
Tips Appendix