ASROCK H81M-ITX User Manual page 27

Serial ATA3 Connectors
(SATA3_0:
see p.9, No. 9)
(SATA3_1:
see p.9, No. 10)
USB 2.0 Headers
(9-pin USB10_11)
(see p.9, No. 8)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.9, No. 16)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
DUMMY
GND GND
P+7 P+6
P-6
P-7
USB_PWR USB_PWR
1
GN D OUT2_L
J_SENSE
PRESENCE# OUT2_R
MIC_RET
MIC2_R
OUT_RET
1
These two SATA3
connectors support SATA
data cables for internal
storage devices with up to
6.0 Gb/s data transfer rate.
Besides two USB 2.0 ports
on the I/O panel, there
are one header on this
motherboard. Each USB
2.0 header can support
two ports.
This header is for
connecting audio devices
to the front audio panel.
MIC2_L
H81M-ITX
23