Table of Contents
Advertisement
SATA Port 5 - Port 6 [RAID]
This item only appears when OnChip SATA Type is set to [RAID]. If SATA ports 5,
6 are configured as [RAID], the ports can only be used under Windows
requested drivers installed. Set to [IDE] instead of [RAID] to access devices on SATA
ports 5, 6 before entering OS. Configuration options: [RAID] [IDE]
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When
read/write of your hard disk errors occur, this feature allows the hard disk to report warning
messages during the POST. Configuration options: [Enabled] [Disabled]
2.6.3
USB Configuration
The items in this menu allow you to change the USB-related features.
The USB Devices item shows the auto-detected values. If no USB device is detected, the
item shows None.
USB Device Enable [Enabled]
Allows you to enable or disable all USB ports. Configuration options: [Disabled] [Enabled]
Legacy USB Support [Enabled]
[Enabled]
[Disabled]
[Auto]
Legacy USB3.0 Support [Enabled]
[Enabled]
[Disabled]
EHCI Hand-off [Disabled]
[Enabled]
[Disabled]
USB Single Port Control
Allows you to enable/disable individual USB ports.
2-18
Enables the support for USB devices on legacy operating systems (OS).
The USB devices can be used only for the BIOS setup program.
Allows the system to detect the presence of USB devices at startup. If
detected, the USB controller legacy mode is enabled. If no USB device is
detected, the legacy USB support is disabled.
Enables the support for USB 3.0 devices on legacy operating systems
(OS).
Disables the function.
Enables the support for operating systems without an EHCI hand-off
feature.
Disables the function.
OS with the
®
Chapter 2: BIOS information
Hide quick links:
Advertisement
Chapters
Table of Contents
