Connecting A Usb Device; Plugging In The Receiver - Pioneer HTP-072 Operating Instructions Manual

Connecting your equipment
•
For instructions on playing the iPod, see Playing an iPod
page 19
.
VSX-324
AV RECEIVER
HDMI iPod iPhone
ET ENTER
MASTER
VOLUME
5V 1A
USB cable that comes
with the iPod
iPod/iPhone
Note
• When the ARC function is ON and the receiver is
connected to a compatible TV with an HDMI cable, and
you switch the input of the TV when the receiver's
selection is iPod/USB input, the receiver may
automatically switch to TV. If this happens, switch the
receiver's input back to the original input, or turn OFF the
ARC function (see The HDMI Setup menu on page 30).
on

Connecting a USB device

It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
1 Switch the receiver into standby then connect your USB
device to the iPod/iPhone terminal on the front panel of
this receiver.
• This receiver does not support a USB hub.
• For instructions on playing the USB device, see Playing a
USB device on page 20.
HDMI iPod iPhone
ET ENTER
This receiver
USB mass
storage device

Plugging in the receiver

Only plug in after you have connected all your components to
this receiver, including the speakers.
1 Plug the AC power cord into a convenient AC power
outlet.
CAUTION
• Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power cord
when your hands are wet as this could cause a short
circuit or electric shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the cord.
VSX-324
AV RECEIVER
Never make a knot in the cord or tie it with other cords.
The power cords should be routed such that they are not
likely to be stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the power
cord once in a while. When you find it damaged, ask your
nearest PIONEER authorized service center or your dealer
for a replacement.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular use,
MASTER
VOLUME
e.g., when on vacation.
Note
5V 1A
• After this receiver is connected to an AC outlet, a 2
second to 10 second HDMI initialization process begins.
You cannot carry out any operations during this process.
The HDMI indicator in the front panel display blinks
during this process, and you can turn on this receiver
This receiver
once it has stopped blinking. When you set ARC at HDMI
setup to OFF, you can skip this process. For details, see
The HDMI Setup menu on page 30.
02
02
17
En