Table of Contents
Advertisement
7. Lift the power supply away from the computer.
8. Slide the power supply cables out of the computer (through the hole).
Replacing the Power Supply
1. Slide the power supply cables through the hole into the computer.
2. Insert the power-supply securing tabs into the power-supply securing slots on the computer, ensuring that each securing tab is connected to its slot on
the computer.
3. Slide the power supply toward the front of the computer.
4. Install the card fan guide:
a. Place the card fan guide into the four securing slots in the computer.
b. Slide the card fan guide to the left until it locks into position.
5. Connect the power supply cables and the card fan cable.
6. Replace the card fan.
7.
Install the
cards.
8.
Close the computer cover
and restart the computer.
Front Panel
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.
Removing the Front Panel
1. Follow the instructions in
"Before You
2.
Open the computer
cover.
3. Disconnect and remove all disk drives (see "Drives").
4. Release the front panel by pressing each of the front-panel release tabs.
There are seven release tabs.
Begin."
Advertisement
Table of Contents
