Advertisement
Setting Up
As shown in the figures below, set up your drum pad on an electronic drum rack or a standard tom stand
(such as a product from the Yamaha WS series).
1.
Take the TP70 drum pad
w
bolt
(by five or six turns).
2.
Slide the drum pad
tighten the S wing bolt
CAUTION
If the wing bolt and other fasteners are not sufficiently tightened, your drum pad may fall, pos-
sibly causing injury. It is important, therefore, that you mount your pad securely on the drum
rack or stand. In addition, you should avoid placing your rack or stand on an uneven surface as
this may cause it to fall over, again increasing the risk of injury.
Pads & Trigger Input Jacks
The functions that the pad can perform will depend on which of your drum module's trigger input jacks it
is connected to. A chart showing the pad functions available with various input jack types can be
accessed from the web site shown below.
http://download.yamaha.com/
TP70
6
Owner's Manual
q
and the S wing bolt
w
q
onto the hexagonal tom holder
w
to secure it in place.
q
w
w
from the package and lightly tighten the S wing
q
e
from the rack or tom stand, and then
e
Advertisement
