Enabling Boot Devices In Setup Utility - HP Mini CQ10-900 User Manual

Enabling boot devices in Setup Utility

The computer will boot to a USB device or a NIC device only if the device has first been enabled in
Setup Utility.
To start Setup Utility and enable a USB device or a NIC device as a boot device, follow these steps:
1. Turn on or restart the computer, and then press
Menu" message is displayed at the bottom of the screen.
2. Press f10
3. To enable bootable media in USB drives, use the arrow keys to select System Configuration >
Device Configurations. Confirm USB legacy support is selected.
NOTE:
at the factory. If the port becomes disabled, reenable it by selecting System Configuration >
Port Options, and then selecting USB Port.
– or –
To enable a NIC device, select System Configuration > Boot Options, and then select PXE
Internal NIC boot.
4. To save your changes and exit Setup Utility, click the Save icon in the lower-left corner of the
screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select File > Save Changes and Exit, and then press enter.
Your changes go into effect when the computer restarts.
NOTE: To connect a NIC to a Preboot eXecution Environment (PXE) or Remote Program Load
(RPL) server without using MultiBoot, press
message is displayed at the bottom of the screen, and then quickly press f12.
to enter Setup Utility.
The USB Port option must be enabled in order to use USB legacy support. It is enabled
esc while the "Press the ESC key for Startup
esc while the "Press the ESC key for Startup Menu"
Enabling boot devices in Setup Utility 63