Remove The Solid State Drive; Supply Power And Power Up The System - Dell Force10 Z9000 Manual

Figure 4-1. The SSD

Remove the Solid State Drive

To remove and replace a SSD, follow these steps:
Step Task
Shut down the system.
1
Loosen the retaining screws on the SSD.
1
Use the handle to pull the SSD out of the slot.
2
Remove the SSD and set it aside.
3
Use the SSD handle to slide the replacement SSD into the slot and firmly press it in place.
4
Finger tighten the retaining screws.
5
Restart the system.
6

Supply Power and Power Up the System

Supply power to the Z9000 after the system is mounted in a rack or cabinet.
Dell Force10 recommends re-inspecting your system prior to powering up. Verify that:
• the equipment is properly secured to the rack and properly grounded.
• the equipment rack is properly mounted and grounded.
• the ambient temperature around the system (which may be higher than the room temperature) is within
the limits specified for the Z9000 system.
• there is sufficient airflow around the system.
• the input circuits are correctly sized for the loads and that you use sufficient over-current protection
devices.
• all protective covers are in place.
NOTE: A US AC power cable is included in the shipping container for powering up an AC power supply. You
must order all other power cables separately.
24 | Install the Z9000
SSD
Handle