Monitor And Debugging Lacp - Dell Force10 MXL Blade Configuration Manual

To configure the LACP long timeout, follow the step below.
Step Task
1 Set the LACP timeout value to 30 seconds.
Figure 16-4 shows the
Figure 16-4. Invoking the LACP Long Timeout
FTOS(conf)# interface port-channel 32
FTOS(conf-if-po-32)#no shutdown
FTOS(conf-if-po-32)#switchport
FTOS(conf-if-po-32)#lacp long-timeout
FTOS(conf-if-po-32)#end
FTOS# show lacp 32
Port-channel 32 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled L - Distribution disabled,
M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state,
P - Receiver is not in expired state
Port TenGig 10/6 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ADEHJLMP Key 1 Priority 128
Note: To view PDU exchanges and the timeout value, use the
refer to Monitor and Debugging

Monitor and Debugging LACP

The system log (syslog) records faulty LACP actions.
To debug LACP, use the following command:
Command Syntax
[no] debug lacp [config | events | pdu [in |
out | [interface [in | out]]]]
no shutdown
command.
LACP.
Command Mode
EXEC
Command Syntax
lacp long-timeout
command. For more information,
debug lacp
Purpose
Debug LACP, including configuration and events.
Link Aggregation Control Protocol (LACP) | 291
Command Mode
CONFIG-INT-PO