Dell 926 All In One Inkjet Printer User Manual page 89

Error Error name:
code:
Error NVRAM R/W
0000
Error Memory failure
0001
Error Hardware failure
0002
Error ROM checksum error
0003
Error Paper Calibrate Fail
1003
Error Flash Programming - out
0200 of memory
Error Print Incomplete (Bad
1201 data to print head or
more data expected for
swath)
Error Data Error
1202
Error Print Head Short
1203
Error Mono TSR Error
1205
Error Color TSR Error
1206
Error Paper system Error
1207
Error Scan Carrier Stall
2200
NOTE: Contact Customer Support at
What it indicates:
Error detected in reading from
or writing to the NVRAM
The printer is unable to initialize
memory.
A general hardware failure has
occurred, and the printer is
unable to detect what part of the
hardware system failed.
A checksum error on the Read-
only memory has occurred.
The printer failed to initialize or
calibrate the paper feed system.
The printer is unable to program
flash memory.
The printer carrier stopped
before a print job was
completed.
Incorrect data has been sent
from the computer to the
printer.
A short circuit in the print head
has occurred.
The printer cannot determine
the temperature of the print
head due to a problem in the
mono TSR circuit.
The printer cannot determine
the temperature of the print
head due to a problem in the
color TSR circuit.
The paper system control failed.
The scan carrier stalled during a
scan job.
www.support.dell.com
Solution:
Press the Power button
the printer.
Press the Power button
the printer.
Press the Power button
the printer.
Press the Power button
the printer.
Disconnect the printer power cable,
check for paper jams, and then
reconnect the power cable.
Press the Power button
the printer.
Press the Power button
the printer.
Press the Power button
the printer.
Disconnect and then reconnect the
printer power cable. Reinstall the
ink cartridges. For more
information, see Replacing Ink
Cartridges.
Reinstall the black ink cartridge. For
more information, see
Cartridges.
Reinstall the color ink cartridge. For
more information, see
Cartridges.
Press the Power button
the printer.
Turn off the printer, wait a few
seconds, and then turn on the
printer.
if the errors are not resolved.
to reset
to reset
to reset
to reset
to reset
to reset
to reset
Replacing Ink
Replacing Ink
to reset