Warning Displays - FujiFilm FinePix 2300 Owner's Manual

Warning Displays

e
The table below lists the warnings that are displayed on the LCD monitor.
Warning Displayed Explanation
The camera batteries are low on charge.
No SmartMedia is loaded, or it is loaded
incorrectly.
The SmartMedia is not formatted.
• The SmartMedia contact area are soild.
• The SmartMedia is damaged.
2
• The SmartMedia format is incorrect.
The SmartMedia is fully recorded.
3
The SmartMedia is write-protected.
• An attempt was made to playback
incorrectly recorded data.
• An attempt was made to playback a
frame not recorded on camera.
The frame number has reached 999-
9999.
70
Remedy
Replace or recharge the batteries.
Load a SmartMedia or reload the SmartMedia
the correct way round.
Format the SmartMedia.
Wipe the contact area on the SmartMedia with a
soft dry cloth. It may be necessary to format the
SmartMedia. If the error message is still
displayed, replace the SmartMedia.
Erase some images or use a SmartMedia that
has ample free space.
Use a SmartMedia that is not write-protected.
Images cannot be played back.
Switch the Frame NO. Memory function off and
use a formatted SmartMedia to take the picture.
Warning Displayed Explanation
There is a strong likelihood of camera
shake because the shutter speed is slow.
A protected frame was erased.
1
You attempted to erase a frame with
7
DPOF settings.
Outside the AE continuous range.
AE
The DPOF file contains an error.
Alternatively, the DPOF file was set up
on a different device.
Prints were specified for more than 1000
8
frames in the DPOF frame settings.
Remedy
Set the flash to Forced Flash mode or use a
tripod.
Remove the protection.
Reset the DPOF settings.
The shot can be taken, but the exposure will not
be correct.
Press the MENU/EXE button to create a new
DPOF file and specify all the DPOF settings
again.
The maximum number of frames for which prints
can be specified on the same SmartMedia is 999.
71