FujiFilm FinePix A600 Owner's Manual page 111

Z Shooting
Matters Problems
Cannot use the
flash.
Flash
The flash settings
are restricted and
cannot be
selected.
The playback
image is dark
even though the
flash was used.
The image is
blurred.
Photographed images
There is speckling
on the image.
Photographed
Recording images images or movies
are not recorded.
Possible causes
The shutter button was pressed while the
flash was charging.
The Shooting mode is set to ,.
The batteries have run out.
Continuous shooting is selected.
The Shooting mode is set to a, ,, .,
or 8.
The subject is too far away.
Your finger was covering the flash.
The lens is dirty.
{ appeared when taking pictures.
| appeared when taking pictures.
The picture was taken with a slow shutter
speed (long exposure) in a high-
temperature environment.
AC power adapter was connected or
disconnected during turning the camera
on.
Solutions
Wait until the charging is completed before
pressing the shutter button.
Change the Shooting mode.
Load new or fully charged batteries.
Set continuous shooting to OFF.
The flash settings are restricted because
the camera settings are tailored to the
scene being shot. Change the Shooting
mode for a wider range of flash settings.
Move to within the effective flash range
before taking the picture.
Hold the camera correctly.
Clean the lens.
Check the focus on the subject and take
pictures.
It may cause camera shake. Hold the
camera steadily.
This is a characteristic of CCDs and does
not indicate a camera fault.
Connect or disconnect the AC power
adapter only when the camera is off.
Failing to turn the camera off first can
result in damage to the xD-Picture Card
or malfunctions during PC connection.
Continued Q
Page
42
38
14,
16, 99
49
38
40, 42
24
98
25,
28,
105
26,
105
—
89,
101
111