Operating With Disposable Propane Cylinders; Operating With Hose Connected To Remote Cylinder; Lighting - Mr. Heater Portable Buddy MH9B Operating Instructions And Owner's Manual

ligHting / Operating instructiOns
FOr use witH dispOsaBle 1 lB. prOpane
cYlinders:
warning: Always inspect propane cylinder and heater
propane connections for damage, dirt, and debris before
attaching propane cylinder. Do not use if head of cylinder is
damaged, punctured or deteriorated.
ALWAYS ATTACH OR DETACH CYLINDER OUTDOORS
AWAY FROM FLAMES, OTHER IGNITION SOURCES, AND
ONLY WHEN HEATER IS COOL TO TOUCH. NEVER SMOKE
WHEN ATTACHING OR REMOVING PROPANE CYLINDER OR
MAKING REMOTE CONNECTIONS!
•
Use only LP-gas cylinders marked in accordance with the
U.S. Dept. of Transportation (DOT).
•
Use only 16.4 oz. (1 lb.) disposable cylinders that mate
with No. 600 valve connection.
•
Heater and attached cylinder must be in an upright posi-
tion during operation.
•
Make sure four-position Control Knob is in "OFF" posi-
tion; see Figure 1.
Figure1
•
Screw 1 lb. disposable LP-gas supply cylinder clockwise
(from bottom) into portable heater until hand-tight.
•
Check cylinder connection for leaks with soapy water at
the threaded connection under the domed plastic cover
where the cylinder screws into the regulator. SEE WARN-
ING! ON PLASTIC COVER.
•
Depress and turn Control Knob counterclockwise to
"PILOT" position and hold for 30-60 seconds.
•
Depress red spark ignition button to light pilot flame
(repeat until pilot lights) and continue to hold Control
Knob down and at "PILOT" position for 30-60 seconds
to enable Pilot Light Safety System.
•
After lighting pilot, release knob. Knob should return
to fully extended position. To operate heater slightly
depress knob and gently turn to lock in desired position.
4
Mr. Heater | Portable Buddy
•
Fully turn Control Knob to "HI" position to light burner
tile. Leave on "HI" position until burner tile turns bright
orange.
•
After burner tile has turned bright orange, adjust heat
output by turning Control Knob to desired position
("LO" or "HI" setting)
warning:
DO NOT OPERATE HEATER UNLESS CONTROL KNOB IS
LOCKED IN A POSITION MARKED "HI", "LO" or "PILOT".
NEVER SET CONTROL KNOB BETWEEN LOCKED POSI-
TIONS. POOR COMBUSTION AND HIGHER LEVELS OF
CARBON MONOXIDE MAY RESULT.
•
To shut off heater, slightly push down and turn Control
Knob clockwise to "OFF" position.
•
cautiOn: After turning heater off, wire guard will
remain hot. Allow to thoroughly cool before storing.
•
Do not operate, store or remove cylinder near flam-
mable items or ignition sources.
• LP-GAS CYLINDERS MUST BE DISCONNECTED FROM
HEATER WHEN NOT IN USE!
ligHting / Operating instructiOns FOr
use witH HOse cOnnected tO a reMOte
cYlinder, MaXiMuM siZe 20 lBs:
•
This Heater may be used in a Recreational Enclosure or
Temporary Construction Work Enclosure with a Remote
Refillable Propane Cylinder ONLY when the Cylinder
is Located Outdoors and the Heater is Used with Mr.
Heater Hose No. F273701, F273702 or F272702 and fuel
filter F273699. Fuel filter must be replaced annually. Or
use F273704 Buddy series hose. Fuel not required.
•
danger: NEVER bring a refillable propane cylinder
indoors. A fire or explosion can occur causing property
damage, serious injury or death!
•
Inspect the hose before each use of the heater. If there
is excessive abrasion or wear, or the hose is cut, replace
prior to using the heater with one of the Mr. Heater
Hose No's. shown above.
•
The propane cylinder must include a listed overfilling
protection device as well as a collar to protect the cylin-
der valve.
•
Heater must be in an upright position during operation.
•
Make sure four-position Control Knob is in "OFF" posi-
tion; see Figure 1, at left.
•
Screw hose connector into regulator on heater and
screw connector on other end of hose into LP-gas supply
cylinder valve. Tighten all hose connections.
• Mr. Heater strongly recommends using disposable fuel
filter F273699 to trap any oil substances when connect-
ed to a remote cylinder that can make heater inoper-
able.
•
Open valve at LP-gas supply cylinder.
•
Check all hose connections for leaks with soapy water at
the threaded connection under the domed plastic cover
Operating Instructions and Owner's Manual