Advertisement
INSTALLATION INSTRUCTIONS
1. Determine mounting configuration (can be mounted in either a horizontal or vertical
orientation).
2. Configure drive for system application.
3. Configure the adapter board for the specific system application (if required).
4. Install adapter board into an unused PC/AT 16 bit slot (if required).
5. Install the I/F cable to the System's 44 pin connector port or adapter board. Ensure Pin 1
is oriented correctly. (Pin 1 on the cable is usually identified by a red or blue stripe.)
6. Set correct drive type in system CMOS.
7. Refer to applicable manuals for software installation instructions.
P/N 480040-G0
8/01
JUMPER
No Jumper
C-D Jumper
B-D Jumper
B-D Jumper
Prohibit A-B Jumper
Prohibit A-C Jumper
FIGURE 2 – MOUNTING HOLE LOCATIONS
P28
DRIVE
-
Master Drive
-
Slave Drive
LOW
Master Drive
HIGH
Slave Drive
-
-
2.5" Hard Disk Drive Installation Notes - 9.5mm Series
-
-
Advertisement
