Download Print this page

Advertisement

TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
MK1504GAL (HDD1285)
1.8-INCH HARD DISK DRIVE
USER MANUAL
Rev 02
11/2006

Advertisement

loading

Summary of Contents for Toshiba MK1504GAL

  • Page 1 TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA MK1504GAL (HDD1285) 1.8-INCH HARD DISK DRIVE USER MANUAL Rev 02 11/2006...
  • Page 2: Table Of Contents

    CONTENTS Introduction...1 Setup ...2 Using the HDD ...3 Specifications ...4 Drive Connectors...6...
  • Page 3: Introduction

    15ms Average Seek Time • ATA (2 - 5) Interface • Ultra DMA 100 • 512KB Buffer • Rotational speed of 4,200rpm • MTTF 300,000 Hours *Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.
  • Page 4: Setup

    Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N. important Note: Disconnect power from your computer system before beginning installation Figure 1. MK1504GAL Side View...
  • Page 5: Using The Hdd

    USING THE HARD DISK DRIVE – MK1504GAL (HDD1285) Backing up Data Files To avoid data loss, regularly back up the data files on the hard disk drive.
  • Page 6: Specifications

    Internal Transfer Rate Host Transfer Rate Ultra DMA mode PIO Mode Interleave Factor *Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes. Internal Drive Characteristics Number of Disks Number of Data Heads Track Density (TPI)
  • Page 7 Physical Height Width Depth Weight Regulatory The drive satisfies the following standards: Underwriters Laboratories (UL) Canadian Standard Association (CSA) C22.2 No. 950 TUV Rheinland EMC - EN50081-1 EMC - EN50082-1 BSMI 0.2" (5.0mm) 2.13" (54.0mm) 3.09" (78.5mm) 1.8oz (51g) typ 1950 EN 60 950 EN50081-1: 1992...
  • Page 8: Drive Connectors

    DRIVE CONNECTORS – MK1504GAL (HDD1285) Figure 1. MK1003GAL HDD - INTERFACE CONNECTOR Interface Connector Drive Side Connector Recommended Host Side Connector MCD-D50 Series by DDK Connectors MCD-D50 Series by DDK Connectors...
  • Page 9 Interface Signals Note: Symbol () in front of signal indicates negative logic. DRIVE INTERFACE SIGNALS SIGNAL RESET DD 7 DD 6 DD 5 DD 4 DD 3 DD 2 DD 1 DD 0 GROUND DMARQ DIOW/STOP DIOR/ -DMARDY HSTROBE IORDY/ -DMARDY/- DSTROBE DMACK...

This manual is also suitable for:

Hdd1285