Advertisement
Step 3: Initial setup of the Converter Box
1. Press BOX
on the remote control to turn on the
Converter Box. The indicator on front panel will turn
yellow (ON mode) form red (STANDBY mode).
• Make sure your TV is on the correct channel (either 3 or
4) or VIDEO mode.
Refer to your TV manual for further instructions.
• The following screen can be seen on your TV when the
correct channel is chosen.
• If you cannot see the above screen on your T V set,
check if :
a) the converter box has been turned on,
b) your T V is on the correct channel (either 3 or 4) or
VIDEO mode. Refer to your T V manual for fur ther
instructions.
c) you have correctly connected the T V set with the
Converter Box.
• If you still do not see the above screen, follow the
following steps to reset the Converter Box to factory
reset status:
- From the "No Signal" screen, press MENU key ;
- Press "5", "6", "2" then you should see the above screen
and please continue the setup.
2. Press 1 (for English), 2 (for Spanish) or 3 (for French) to
select the menu language.
Step 4: (Optional) Program the remote control to control your TV set
You can control TV sets of all major brands after programming the Converter Box remote control.
For detail instructions, please refer to your user manual.
3. Press 1 to start automatic channel search.
• When the scan fi nishes, the Channel List menu displays
the found channels.
• Reposition the antenna and perform the automatic
channel scan again if you cannot find all available
channels by pressing MENU key.
• The Conver ter Box is also compatible with Smar t
Antennas which can provide improved reception over
standard indoor antennas.
• If a Smart Antenna is connected, press 1 for Quick Scan
or 2 for Full Scan. A full scan with Smart Antenna may
take around 40-50 minutes.
4. The Channel List is displayed once scanning is fi nished
Press
or
to select channel and OK to start viewing.
Your Converter Box is now ready for use!
Tip:
To continue to view non-digital TV broadcasts,
if available, press the BOX
place the Converter Box in stand-by mode (red
light), then switch your TV to channel 3 or 4 (depending
on which channel the Converter's CH3/CH4 selector
switch is set to).
You must have the RF coaxial cable connected to your TV
input, in order to watch non-digital TV broadcasts.
Please read the User Manual for further details
on using the Converter Box.
on your remote to
3
Advertisement
