Advertisement
Step 3: Initial setup of the Converter Box
1. Press BOX
on the remote control to turn on the
Converter Box. The green indicator on front panel will turn ON.
• Make sure your TV is on the correct channel (either 3 or 4)
or INPUT or VIDEO mode.
Refer to your TV manual for further insturctions.
• The following screen can be seen on your TV when the
correct channel is chosen.
Language
Choose the language to be used in the menu system.
English - 1
Menu text is displayed in English.
Español - 2
El texto del menú se exhibe en
español.
Français - 3
Le texte des menus est affiché en
français.
• If you cannot see the above screen on your TV set, check if :
a) the converter box has been turned on,
b) your TV is on the correct channel (either 3 or 4) or INPUT
or VIDEO mode. Refer to your TV manual for further instructions.
c) you have correctly connected the TV set with the
Converter Box.
• If you still do not see the above screen, follow the following
steps to reset the Converter Box to factory reset status:
- From the "No Signal" screen, press MENU key ;
- Press "5", "6", "2" then you should see the above screen
and please continue the setup.
2. Press 1 (for English), 2 (for Spanish) or 3 (for French) to
select the menu language.
Step 4: (Optional) Program the remote control to control your TV set
You can control TV sets of all major brands after programming the Converter Box remote control.
For detail instructions, please refer to your user manual.
DTA800B1_QSG_EN_V1_0.pdf
p.3
Language
Choose the language to be used in the menu system.
English - 1
Menu text is displayed in English.
Español - 2
El texto del menú se exhibe en
español.
Français - 3
Le texte des menus est affiché en
français.
3. Press 1 to start automatic channel search.
Channel Scan
Channel scan will search for channels available in your
area. You may have to re-adjust the antenna and
retry the scan to capture all available channels.
Begin - 1
• When the scan nishes, the Channel List menu displays the
found channels.
• Reposition the antenna and perform the automatic
channel scan again if you cannot nd all available
channels by pressing MENU key.
• The Converter Box is also compatible with Smart Antennas
which can provide improved reception over standard indoor
antennas.
• If a Smart Antenna is connected, press 1 for Quick Scan or
2 for Full Scan. A full scan with Smart Antenna may take
around 40-50 minutes.
4. The Channel List is displayed once scanning is nished.
Press
or
to select channel and
Channel List
Channel
What's on Now
2-1
KTVU Stored Current program Next program
2-2 KTVU Stored Current program Next program
4-1 KRON Stored Current program Next program
Your Converter Box is now ready for use!
Tip:
To continue to view non-digital TV broadcasts,
if available, press the BOX
on your remote to place the
__________
Converter Box in stand-by mode (amber light), then you
can tune your TV to any available non-digital channels
(refer to your TV controls). You must have the RF coaxial
cable connected to your TV input, in order to watch
non-digital TV broadcasts.
Please read the User Manual for further details on
using the Converter Box.
Start channel search.
OK to start viewing.
What's on Next
Hide quick links:
Advertisement
