Table of Contents
Advertisement
button: Remote Beeps
▀
Disarm LED OFF: The remote will not emit beeps except when pro-
gramming.
▀
Disarm LED
▀
Disarm LED blinking: The remote will emit beeps only for alarm
A U
X
trigger messages from the alarm system.
button: Runtime Low Alert feature
Note: This feature is not available on the 1-way remote.
▀
Remote Start LED OFF: The remote will ignore Runtime Low Alert
messages.
▀
Remote Start LED ON: The remote will emit feedback output for
Runtime Low Alert messages.
These messages will be automatically sent while Remote Start is ON to
alert you when the runtime remaining is at 3 minutes, and again at 1
minute before shut down.
Note: This feature is not available on the 1-way remote
button: Page mode/Power saver
A U
X
Note: This feature is not available on the 1-way remote.
▀
Aux LED
OFF:
from the system to extend battery life. Note: This means the remote
will not receive alarm trigger pages.
▀
Aux LED
ON:
system
▀
Aux LED blinking: Power saver mode (see note below)
Note: Power saver automatically turns off the remote pager if a but-
ton on the remote has not been pressed for more than 72 hours and
will be restored after any button on the remote is pressed.
2
3
4
The remote will emit beeps normally.
ON:
5
6
The remote will not wake up and listen for messages
the remote will wake up to listen for messages from the
© 2008 Directed Electronics—all rights reserved
Advertisement
Table of Contents
