Silent Mode - Python 650ESP Owner's Manual

without a transmitter, you must have the vehicle's ignition key
and know where the Valet
the installer for the location of the Valet switch.
To disarm the security system,
turn the ignition to the "on"
position. Press the Valet switch
the selected number of times (1-
5 times) within 15 seconds. The
system should now disarm. If it
does not, you may have waited
too long; turn the ignition off
and on and try again.
LOCATION OF VALET SWITCH______________________________
IMPORTANT! The unit can be programmed to respond to 1-5 pulses of
the Valet ® switch for the disarm function. Be sure to check with the
installer for the desired programming.

Silent Mode

To temporarily turn off the arm or disarm chirps, use Silent Mode
Simply press briefly before arming or disarming, and the con-
firmation chirp(s) will be eliminated for that one operation only.
If you want the arm/disarm chirps turned off permanently, your
dealer can do this for you.
NOTE: The Warn Away
tem is armed using Silent Mode. This ensures that no chirps will be emit-
ted by the siren in an area you want chirp-free. The system is still fully
capable of triggering. Only the Warn Away
1999 Directed Electronics, Inc.
©
® switch is located. Be sure to check with
® response to lighter impacts is bypassed if the sys-
® response is bypassed.
DRW-35
™ .
11