Power Acoustik PTID-8940NRBT Gen 2 Owner's Manual page 18

15. Eject
Press to eject / load a disc.
16. RESET
Press and hold this button to switch back to all the original factory settings.
Keep in mind this will erase all your preset radio stations and any EQ settings you
may have made and saved.
17. ANGLE + / END CALL / 18. ANGLE + / CALL
Adjust the view angle of the monitor to choose the best displaying effect.
1- Continual angle adjustment
Hold on pressing the [ANGLE +] / [ANGLE -] buttons to adjust the angle of TFT
monitor upward / downward by continual increasing / decreasing.
2- Single step angle adjustment
Press the [ANGLE +] / [ANGLE -] buttons to adjust the angle of TFT monitor upward /
downward by singly increasing / decreasing.
Bluetooth Mode, press the [CALL] button to receive a cell phone call, press the [END
CALL] button to reject or hang up a call.
19. DISPLAY
Press to display the current playback information.
20. OPEN / CLOSE
When unit power off, press the [OPEN] button to turn unit on and the monitor will
spread out and turn around to the last angle position.
When unit power on, press the [OPEN] button, the monitor will spread out and turn
around to the last angle position; Press the [CLOSE] button, the monitor will turn
downward and completely retract in.
21. OUT / 22. IN
Press the [OUT] / [IN] buttons to move the monitor forward / backward by singly step.
There are 2 steps to move the monitor forward / backward totally.
NAVI mode, hold on pressing the [OUT] / [IN] buttons to decrease / increase the
brightness of panel.
23. MENU
Press to return the main menu.
24. NAVI / SYSTEM
Press to enter / exit the NAVI mode.
Hold on pressing to enter / exit the System Parameter Setup menu.
Protection of the TFT Monitor
During the movement of the TFT monitor, if it is halted by force, then the unit will
begin self-protection to prevent from any damage on the motorized mechanical
structure.
Press the [OPEN] button or shut down the ACC and then restart, the TFT monitor will
act as the follow list to recover; if not, then please consult with an authorized service
center.
Press the [OPEN] Shut down the
Halt Self-protection
button ACC and restart
- 17 -