Adjusting Your Monitor Image; Using The Direct Access Controls; Using The On-Screen Display Controls - Lenovo L193 User Manual

Adjusting your monitor image

This section describes the control features used to adjust your monitor image.

Using the direct access controls

The direct access controls can be used when the On- Screen Display (OSD) is not
displayed.
Note: The direct access controls are blue.
Table 2-1. Direct access controls
Icon

Using the On-Screen Display controls

The settings adjustable with the user controls are viewed through the On-Screen
Display, as shown below.
To use the controls:
1. Press
2. Use
3. Press
4. Press and hold
5
Control
Image Setup
Novo Vision
Menu
to open the main OSD menu.
or to move among the icons. Select an icon and press
that function. If there is a sub-menu, you can move between options using
or , then press to select that function. Use
Press to save.
to move backwards through the sub-menus and exit from the OSD.
for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold
and allow adjustments to the OSD.
.
Enables DDC/CI by default. Use OSD Exit Key,Press and hold the
10 seconds to disable / enable DDC/CI function. The words " DDC/CI disable" shows
on the screen.
Description
Activates automatic image adjustment.
Direct access to NOVO Vision.
Lock or unlock the OSD.
for 10 seconds to unlock the OSD
Chapter 2. Adjusting and using your monitor
to access
or to make adjustments.
buttons for
2-3