Replacing An Adapter - Lenovo ThinkCentre 8116 Hardware Replacement Manual

5. Remove the memory module being replaced by opening the retaining clips as
6. Position the replacement memory module over the memory connector. Make
7. Reinstall the PCI riser assembly and adapters.
8. Go to "Completing the CRU replacement" on page 28.

Replacing an adapter

To replace the adapter:
shown.
sure the notch 1 on the memory module aligns correctly with the connector
key 2 on the system board. Push the memory module straight down into the
connector until the retaining clips close.
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Quick Reference that was included with your computer or in the
Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick
Reference or the HMM, go to the Support Web site at
http://www.lenovo.com/think/support.
1. Open the computer cover. See "Opening the cover" on page 5.
Chapter 2. Replacing hardware
19