Listening Through A Receiver; Check Points Before Requesting Service - Samsung LN40M81B Owner's Instructions Manual

listening through a receiver

you can listen to sound through a receiver instead of the tV speaker.
. Press the anynet+ button.
Press the ▲ or ▼ button to select receiver, then press the EntEr button.
. Press the ◄ or ► button to select to on, then press the EntEr button.
Now you can listen to sound through the receiver.
. Press the ExIt button to exit.
➣
When the receiver is set to On, you can listen to the TV sound through the 2-channel
receiver.
➣
If the receiver is exclusively for a home theater only (supporting audio only), it may not
appear in the device list.
➣
In case of a content with copyright problem, listening through the receiver may not
properly operate.
➣
When listening through the receiver, there are restrictions for using the PIP and audio-related menu.

Check Points before requesting Service

Symptom Solution
anynet+ does not ■
work. ■
■
■
■
■
■
■
■
■
I want to start ■
anynet+.
■
I want to exit anynet+. ■
■
■
the Connecting to
anynet+ device... ■
message appears on ■
the screen.
the anynet+ device
You cannot use the play function when Plug & Play is in progress.
does not play.
the connected device ■
is not displayed. ■
■
■
■
the tV program
Check whether the antenna jack on the recording device is properly connected.
cannot be recorded.
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
Connect only one receiver.
Check if the Anynet+ device power cord is properly connected.
Check the Anynet+ device's Video/Audio/HDMI cable connections.
Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
Check whether the TV remote control is in TV mode.
Check whether it is Anynet+ exclusive remote control.
Anynet+ doesn't work at a certain condition. (Searching channels)
When connecting or removing the HDMI cable, please make sure to search devices again or restart your
TV.
Check if the Anynet+ Function of Anynet+ device is set on.
Check if the Anynet+ device is properly connected to the TV and check if the Anynet+ (HDMI-CEC) is set to
On in the Anynet+ Setup menu.
Press the tV button on the TV remote control to switch to TV. Then press the Anynet+ button to show the
anynet+ menu and select a menu you want.
Select View tV in Anynet+ menu.
Press the SourCE button on the TV remote control and select a device other than Anynet+ devices.
Press any of Ch, Ch lISt, PrE-Ch, and such to change to the
TV mode. (Note that the channel button operates only when a tuner-embedded Anynet+ device is not
connected.)
You cannot use the remote control when you are configuring Anynet+ or switching to a view mode.
Use the remote control when the Anynet+ setting or switching to view mode is complete.
Check whether or not the device supports Anynet+ functions.
Check whether or not the HDMI cable is properly connected.
Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
Search Anynet+ devices again.
You can connect an Anynet+ device using the HDMI cable only. Some HDMI cables may not support
Anynet+ functions.
English - 5
air 8
View tV
Select Device

record

menu on Device

Device operation

receiver :on

Setup

move
Enter
Exit