Samsung SCH-3500 series Service Manual page 28

Command No. Signal. Name
(OP, AB, RB)
43(AB, 0, 0) T_DTMFOFF_I
44(B0, 0, 0) T_COMPANDORON_I
45(B1, 0, 0) T_COMPANDOROFF_I
46(B2, 0, 0) T_AMPS_VCLINE_I*
47(B3, 3, 0) T_AMPS_AUD_GAIN_I
48(B4, 0, 0) T_VIBRATOR_ON_I
49(B5, 0, 0) T_VIBRATOR_OFF_I
50(B6, 0, 4) T_BATT_TYPE_I
51(B7, 1, 1) T_BBA_I
52(B9, 2, 2) T_HW_VERSION_I
57(BC, 0, 0) T_MIC_ON_I
58(BD, 0, 0) T_MIC_OFF_I
59(BE, 0, 0) T_ALLPATH_I
60(BF, 3, 0) T_AMPS_TX_GAIN_I
61(C0, 3, 0) T_AMPS_RX_GAIN_I
62(C1, 3, 0) T_DTMF_VOL_TX_I
63(C2, 3, 0) T_TX_LIMITER_I
64(C3, 3, 0) T_AMPS_SAT_LEVEL_I
65(C4, 3, 0) T_AMPS_FREQ_SGAIN_I
66(C5, 3, 0) T_AMPS_ST_GAIN_I
67(C6, 3, 6) T_READ_BATT_I
68(C8, 0, 3) T_VBATT1_I
69(C9, 0, 3) T_VBATT2_I
70(CA, 3, 0) T_WRITE_BATT_I
71(D1, 3, 0) T_CDMA_TXADJ_I
72(D2, 3, 0) T_AMPS_TXADJ_I
73(D3, 1, 0) T_SET_PA_R_I
74(D4, 4, 0) T_TXRAS_ADJ_I
75(D5, 0, 3) T_READ_RSSI_I
76(D5, 3, 0) T_WRITE_RSSI_I
SAMSUNG Proprietary-Contents may change without notice
2)3)
2)3)
2)3)
2)3)
2)3)
2)3)
2)3)
1)
3)
3)
3)3)
2)
2)
2)
3)
3)
6-10
Description
Deactivate DTMF generator.
Enable the compressor and expandor.
Disable the compressor and expandor.
Enter Analog voice channel state.
FM audio gain.
Activate a vibrator.
Deactivate a vibrator.
Battery type.
BASIC supplier
HW version
Mic path on.
Mic path off.
Set RX Path, TX path Unmute to Earpiece.
AMPS TX Audio Gain Control.
AMPS RX Audio Gain Control.
AMPS TX DTMF Gain Control.
AMPS TX Limiter Gain Control.
AMPS TX SAT level Control.
AMPS TX Master Gain Control.
AMPS TX ST Gain Control.
Read low batt in the standby, talk mode.
Set the low battery position in the standby.
Set the low battery position in the talking.
Write low battery Level Value to NVM.
Change pdm TX AGC in CDMA.
Change pdm TX AGC in AMPS.
Set PA R1, R0 in CDMA.
TX Ras table adjust.
Read a RSSI.
Writes RSSI.
Circuit Description