Table of Contents
Advertisement
5
1) Screw up the FOLDER UPPER at the above
two points.[M1.4*L2.5]
※ caution
1) Be careful not to make scratch and molding
damage!
2) Use 1.1 ± 0.2 Kgf.cm!
7
1) Insert LCD FPCB[which is connected to
FOLDER] into the bottom of FRONT Hinge.
2) The FOLDER's projection inserts the
FRONT'S hole when Projection is pushed
3) Assemble FOLDER with FRONT
※ caution
1) Be careful not to make scratch and molding
damage!
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
6
SCREW CAP
1) Attach Screw rubber caps on the screws
by using a pincette.
※ caution
1) Be careful not to make scratch and molding
damage!
8
1) Insert the KEYPAD.
2) Attach side volume key
2) Insert PBA into FRONT.
3) Connect LCD FPCB to PBA CONNECTOR.
※ caution
1) Be careful not to insert keypad into FRONT
incorrectly
