Table of Contents
Advertisement
Disassembly and Assembly instructions
5
1) Screw up the FOLDER UPPER at the above
two points.(M1.4xL3.5)
1) Be careful not to make scratch and
molding damage!
2) Torque 1.0 ± 0.1 Kgf.cm!
7
1) Insert LCD FPCB[which is connected to
FOLDER] into the bottom of FRONT Hinge.
2) The FOLDER's projection inserts the
FRONT'S hole when Projection is pushed
3) Assemble FOLDER with FRONT
4) Attach Gasket tape.
※ caution
1) Be careful not to make scratch and
molding damage!
This Document can not be used without Samsung's authorization
SAMSUNG Proprietary-Contents may change without notice
6
1) Attach Screw rubber caps on the screws
by using a pincette.
※ caution
1) Be careful not to make scratch and
molding damage!
2) Be sure to push the rubbers.
8
Attach FRONT
1) Attach FRONT Dust TAPE as a above
picture is shown.
※ caution
1) Be careful not to make scratch and
molding damage!
6-4
Dust TAPE
Advertisement
Table of Contents
