Samsung SCH-A205 Service Manual page 19

E. "0 9 0 3 6 3 #" : Set to '0363' channel.
F. "0 7" : Carrier On.
G. The command "73" is ON/OFF of Tx drive Amp.
In case of Tx PWR output bellow - 6dBm, set to "0".
In case of Tx PWR output above - 6dBm, set to "1".
H. "3 4" : Spread spectrum to 1.23MHz band width.
I. "7 1 * * * " : Adjust RF power level.
"* * *" means AGC level and AGC level range is f rom 000 to 511.
2-2.AMPS(FM)
A. Enter to Test Mode ("* 7 5 9 # 8 1 3 5 8 0").
B. "0 1" : Suspend.
C. The command "21" is mode and channel change
"10000" or "10001" : AMPS's Sytem A and Sytem B
and Push the Navigation key to save.
D. To finish the Test Mode, You should enter the command "0 2",
and enter to Test Mode ("* 7 5 9 # 8 1 3 5 8 0").
"0 1" : Suspend.
E. "4 6" : Vocoder initial to Analog mode.
F. "0 9 0 3 6 3 #" : Set to '0363' channel.
G. "0 7" : Carrier On.
H. The command "73" is ON/OFF of Tx drive Amp. In case of AMPS, set to "1".
I. "7 2 * * * " : Output RF power level is set as power level 2
"* * *" means AGC level and AGC level range is f rom 0 to 511.
J. "1 0 2" : RF Power level control, 2(0~7) means power level .
SAMSUNG Proprietary - Contents may change without notice 5-6