Samsung Anycall SGH-N700 Service Manual page 9

Samsung mobile phone service manual
Hide thumbs Also See for Anycall SGH-N700:
Table of Contents

Advertisement

Circuit Description
8) Trident
Trident is consisted of ARM core and DSP core. It has 20K*16bits RAM 144K*16bits ROM in the DSP. It has
4K*32bits ROM and 2K*32bits RAM in the ARM core. DSP is consisted of timer, one bit input/output unit(BIO), JTAG,
EMI and HDS(Hardware Development System). ARM core is consisted of EMI, PIC(Programmable Interrupt Controller),
reset/power/clock unit, DMA controller, TIC(Test Interface Controller), peripheral bridge, PPI, SSI(Synchronous Serial
Interface), ACCs(Asynchronous communications controllers), timer, ADC, RTC(Real-Time Clock) and keyboard interface.
DSP_AB[0~8], address lines of DSP core and DSP_DB[0~15], data lines of DSP core are connected to CSP2200. A[0~20],
address lines of ARM core and D[0~15], data lines of ARM core are connected to memory, LCD and YMU762.
ICP(Interprocessor Communication Port) controls the communication between ARM core and DSP core.
CSROMEN, CSRAMEN and CS1N to CS4N in the ARM core are connected to each memory. WEN and OEN control the
process of memory. External IRQ(Interrupt ReQuest) signals from each units, such as, YMU, Ear-jack, Ear-mic and
CSP1093, need the compatible process.
Some PPI pins has many special functions. CP_KB[0~9] receive the status from key FPCB and are used for the
communications using data link cable(DEBUG_DTR/RTS/TXD/RXD/CTS/DSR).
And UP_CS/SCLK/SDI, control signals for CSP2200 are outputted through PPI pins. It has signal port for
charging(CHG_DET), SIM_RESET and FLIP_SNS with which we knows open.closed status of folder. It has JTAG control
pins(TDI/TDO/TCK) for ARM core and DSP core. It recieves 13MHz clock in CKI pin from external TCXO and receives
32.768KHz clock from X1RTC. ADC(Analog to Digital Convertor) part receives the status of temperature, battery type and
battery voltage. And control signals(DSP_INT, DSP_IO and DSP_RWN) for DSP core are used. It enables main LCD with
DSP IP pins.
8) X-TAL(13MHz)
This system uses the 13MHz TCXO. AFC control signal form CSP1093 controls frequency from 13MHz x-tal. This clock
is fed to CSP1093,Trident,YMU759 and Silab solution.
2- 5
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization

Advertisement

Table of Contents
loading

Table of Contents