Xerox DocuPrint C3055 DX Settings Manual page 20

Extension
Sets the extension (first 2 bytes) of an extended command if you want to enable printing by
text codes. The codes between 0x21 and 0x7d are valid. The default is [&%].
Note
• An extended command is prefixed with an extender followed by command identification data and
parameter data (if necessary). An extension is the first 2 bytes of an extended command (ESC (1BH in
hexadecimal) followed by a ";" (semicolon or 3 BH in hexadecimal)).
Form Overlay
Performs Form Overlay if you select a form registered in the ESC/P mode (No. 01 - 64). The
default is [Off].
Note
• This setting is not affected by extension commands sent from users.
• If you delete a form after selecting it, it still appears on the menu, but disappears if you switch the
screens using <
• If you select this feature when there is no form registered in the printer, the display shows [Not
registered].
Stored Prog. Menu
This menu allows you to store the settings in the NV memory (No. 01 - 05) and recall them
whenever you want.
At startup
The [At startup] memory is NV memory (No. 01 to 05) stored under [Store] and recalled
when the power is switched off or when the system is initialized.
Enter the number of NV memory you want to recall.
The default is [Factory Defaults], which recalls the factory default settings.
Retrieve
Recalls and retrieves the settings stored in the printer.
Enter the number of memory you want to recall.
The default is [Factory Defaults], which recalls the factory default settings.
Store
There are two types of memory: ROM that stores the factory default settings and NV
memory (No. 01 to 05) that stores the user-defined settings.
The NV memory (No. 01 to 05) allows you to store the settings of mode menus in groups.
By storing the settings, you can easily recall them and do not need to enter them every time
you switch on the printer.
The stored settings will be retained until you initialize the NV memory or delete the settings.
Delete
Deletes the settings stored in the NV memory.
Set the number of memory to be deleted.
Note
• When no setting is stored in the NV memory, [No.01] - [No.05] do not appear on the display, and [Not
registered] appears instead.
20
2 Setting the ESC/P Mode
> or < >. If you delete the form, this setting changes to [Off].