Honda 2011 CIVIC COUPE Owner's Manual page 309

OIL FILTER
DX, DX-G, LX, SE, EX, EX-L
Remove the oil filter, and let the
3.
remaining oil drain. A special
wrench (available from your
dealer) is required.
Make sure the oil filter gasket is
not stuck to the contacting surface
of the engine. If it is, remove it
before installing a new oil filter.
Si
Install a new oil filter according to
4.
the instructions that come with it.
Make sure to clean off any dirt
and dust on the contacting surface
of a new oil filter.
5. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
29 lbf·ft (39 N·m , 4.0 kgf·m)
Changing the Engine Oil and Filter
6. Refill the engine with the
OIL
recommended oil.
FILTER
Engine oil change capacity
(including filter):
DX, DX-G, LX, SE, EX, EX-L
3.9 US qt (3.7 )
Si
4.6 US qt (4.4 )
7. Reinstall the engine oil fill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn off the
engine, and check your work.
8. Let the engine run for several
minutes, then check the drain bolt
and oil filter for leaks.
CONTINUED
303