Table of Contents
Advertisement
Using a system protecing:
You can only enter the BIOS setup utility only when the computer
before the Windows splash screen appears. If your computer is
already turned on, reboot your computer and press the F2 key to
enter the setup utility.
Security menu
Help
A Supervisor Password is required before you set User Password.
After selecting Change Supervisor Password, enter a new pass-
word then re-enter it to confirm. The password you enter should
contain up to 6 alphanumeric characters. If you make a mistake
while entering your password, you can always press Esc to start
over.
You can enter into the setup utility to change or remove user pass-
words; however, you can not change or remove the Supervisor
Password, nor can you access the diskette.
To input, change, or disable hard drive password. When shown as
or disabled. To change or disable the function, turn off the system
and enter Setup right after turning it back on.
Password. Your notebook service center may not be able to re-
13
Advertisement
Table of Contents
